Filter
Top Products
Getting Set Up
2
User Manual 2-3
Choosing a printer location
To ensure proper printer operation:
1.
Install the printer on a ßat surface. The degree of tilt should be no
more than 3 degrees, approximately equivalent to lifting one side
of the printer 2 cm (0.75 in.) off a ßat surface.
2.
Allow at least 5 cm (2 in.) clearance on each side of the printer for
proper ventilation and to prevent the printer from overheating.
Caution
Some of the printer’s internal parts may be damaged or the
printer may not operate properly if the printer isn’t adequately
ventilated. Avoid leaving loose paper or packing materials
next to the vent on the right side of the printer; they may
adhere to the vent, causing the printer to overheat.
Removing the packing material
Remove the plastic bag and packing materials surrounding the printer.
Note
Save all boxes and packing material in case you need to ship the
printer later.
Registering the printer
Your product registration card is contained in the Register Now! envelope
that is shipped with your printer. Fill out the appropriate card (U.S. or
international versions) and mail it. By registering your printer with
Tektronix, you validate the product warranty and ensure that you will
receive information about upgrades, service, and accessories. You can also
register on-line at the Tektronix web site:
http://www.tek.com./Color_Printers/