Filter
Top Products
AMD Geode™ SC1200/SC1201 Processor Data Book 65
Signal Definitions
32579B
3.4.15 AC97 Audio Interface Signals
Signal Name Ball No. Type Description Mux
BIT_CLK U30 I Audio Bit Clock. The serial bit clock from the codec.
Note: If selected as BIT_CLK function but not used, tie
BIT_CLK low.
F_TRDY#
SDATA_OUT P29 O Serial Data Output. This output transmits audio serial
data to the codec.
TFT_PRSNT (Strap)
SDATA_IN U31 I Serial Data Input. This input receives serial data from
the primary codec.
Note: If selected as SDATA_IN function but not used,
tie SDATA_IN low.
F_GNT0#
SDATA_IN2 AL8 I Serial Data Input 2. This input receives serial data from
the secondary codec. This signal has wakeup capability.
---
SYNC P30 O Serial Bus Synchronization. This bit is asserted to syn-
chronize the transfer of data between the SC1200/
SC1201 processor and the AC97 codec.
CLKSEL3 (Strap)
AC97_CLK P31 O Codec Clock. It is twice the frequency of the Audio Bit
Clock.
---
AC97_RST# U29 O Codec Reset. S3 to S5 wakeup is not supported
because AC97_RST# is powered by V
IO
. If wakeup from
states S3 to S5 are needed, a circuit in the system board
should be used to reset the AC97 codec.
F_STOP#
PC_BEEP V31 O PC Beep. Legacy PC/AT speaker output. GPIO16+
F_DEVSEL#
3.4.16 Power Management Interface Signals
Signal Name Ball No. Type Description Mux
CLK32 AH8 O 32.768 KHz Output Clock ---
GPWIO0 AH6 I/O General Purpose Wakeup I/Os. These signals each
have an internal pull-up of 100 KΩ.
---
GPWIO1 AK5 ---
GPWIO2 AJ6 ---
LED# AL4 O LED Control. Drives an externally connected LED (on,
off or a 1 Hz blink). Sleeping / Working indicator. This sig-
nal is an open-drain output.
---
ONCTL# AJ5 O On / Off Control. This signal indicates to the main power
supply that power should be turned on. This signal is an
open-drain output.
---