Filter
Top Products
10. Lamp replacement
Important
• When the operation times of both lamps have exceeded 4000 hours
3
, you can operate the projector only for 3 minutes after
turning on the power. During this time, carry out steps 15 to 20 to reset the lamp operation times.
• The projector doesn’t turn on if the lamp cover isn’t attached securely.
• Be sure to reset the lamp operation time whenever you replace the lamp.
• Do not reset the lamp operation time unless you replace the lamp.
• The lamp is fragile. If it is broken, be careful not to cut y ourself with glass fragments.
CAUTION: This projector uses a lamp that contains mercury. Disposal of the lamp or the projector with the
lamp may be regulated due to environm ental cons iderations. For disposal or recycling information, please
contact your local authorities or the Electronic I ndustries A lliance: www.eiae.org. ( For the U.S. only.)
3. When LAMP MODE is set to STANDARD, this duration will be shorted to 2000 hours.
R5905597 PHXX SERIES 28/01/2014 97