Filter
Top Products
7. Initial network settings
→ The setting c hange dialog is displayed . After t he dialog disappears, the NE TWORK menu is displayed.
→ Itmaytakesometimetoreflect the settings.
7.5 Setting the control system
How to set
1. Display the NETWORK menu.
2. Press the ▲ or ▼ key to select CONTROL SYSTEM.
CONTROL SYSTEM
STANDARD
Image 7-19
3. Press the ENTER key.
:CONTROL SYSTEM
OK : ENTER CANCEL : MENU
STANDARD
Image 7-20
4. Press the ◄ or ► key to select STA NDARD , AMX ,orCRE STRON .
STANDARD Select this setting when us ing Projector Toolset, or RS-232C commands via LAN terminal.
AMX
Select this setting when using the c ontroller of AMX.
CRESTRON Select this setting when using the controller or software of Cr estron Electronics, Inc.
Important: PJLink™ works regardless of the setting of CONTROL SYSTEM.
5. Press the ENTER key.
Itmaytakesometimetoreflect the settings.
7.6 Initialization of Network Settings
How to initialize
1. Display the NETWORK menu.
2. Press the ▲ or ▼ key to select NETWORK RESET.
NETWORK RESET
OK
Image 7-21
3. Press the ENTER key.
Confirmation dialog appears.
4. Press the EN T E R key again, and the Network S ettings can be in
itialized (except for IP CONFIG).
To cancel the initialization, press the MENU key.
Itmaytakesometimetoreflect the settings.
7.7 How to Use Network Function
Overview
• When connecting a c omputer and projector with LAN, con figure the both IP Addresses in the same network group.
If connecting in different network group, be sure to use a router. As for the settings of a router, ask the network administrator.
•Configure the IP CONFIG correctly. If the settings are not correct, the communication may be unavailable. For the detail,
consult the network administrator.
• Depending on the se ttings of standby mode of the pr
ojector, LAN function may be unav ailable.
80
R5905597 PHXX SERIES 28/01/2014