Filter
Top Products
5. Advanced menu
Item
Setti ng
Function
NETWORK
CERTIFICATION
ON
/OFF
Select whether to enable the network certification or not. Select OFF
for normal use.
IP CONFIG
ENTER
Select this s etting for IP Configura tion.
DHCP ON Select this setting when you obtain IP CONFIG automatically by
DHCP server.
OFF Select this setting when you set IP CONFIG manually.
IP ADDRESS
***.***.***.***
Press the ENTER key to set IP ADDRESS. W hen DHCP is set to ON,
you cannot change this setting.
SUBNE T MASK
***.***.***.***
Press the ENTER key to set SUBNET MASK. When DHCP is set to
ON, you cannot change this setting.
DEFAULT GATEWAY
***.***.***.***
Press the ENTER k ey to set D EFAULT GATEWAY. Wh en DHCP is set
to ON, you cannot change this setting.
MAC ADDRESS
xx-xx-xx-xx-xx-xx
Displays MAC ADDRESS.
SAVE SE T TINGS
OK
Saves the IP CONFIG settings. When the IP CONFIG is not changed,
you cannot select SAVE S ETT INGS.
CONTROL S YSTEM
STANDARD
Select this setting w h en using Projec tor Toolset.
AMX
Select when using a controller made by A MX .
CRESTRON
Select this s etting when using the c ontroller or software of Crestron
Electronics, Inc.
NETWORK RESET
OK
Resets the Network Setting.
NETWORK RESTART
OK
Press the ENTER key to restart the network function.
• AMX does not support network c ertific ation. When setting CONTROL SYSTEM to AMX, set NETWORK CERTIFICATION to
OFF.
5.10 INFORMATION menu
Overview
IMAGE INSTALL1 INSTALL2
MULTI-
SCREEN
FEATURE SIGNAL NETWORK INFO
60.00 Hz
RESOLUTION
1024 x 768
VERTICAL
FREQUENCY
48.36 kHz
5 WIRE
HORIZONTAL
FREQUENCY
SYNC. TYPE
SERIAL NUMBER
FILTER TIME
*****
H
********
...
NEXT LAMP RELAY
COMPUTER1INPUT
*
D
**
H
LAMP 1 TIME (LOW)
LAMP 2 TIME (LOW)
****
H
****
H
Image 5-20
Item Description
LAMP 1 TIME (LOW) This item shows the lamp operation time calculated b ased on that the LAMP MODE of LAMP
1isLOW.
→ When the LAMP MODE is S TANDARD, this item shows a longer lamp operating time than
the actual time.
→ When the lam p operating time is 0 to 10 hours, “0H” is displayed. The lamp operating time
exceeding 10 h ours is indicated by the actual hours.
→ When the lamp operating time reaches 3000 hours, the bar turns to yellow. W hen it reaches
3800 hours, the bar turns to red.
→ The icon displayed to the right of the bar shows the lamp status. Yellow: On, Red: End of lamp
life or err or such as illumination failure, Black: Off
52 R5905597 PHXX SERIES 28/01/2014