Filter
Top Products
9. Advanced features
3. Press ENTER key.
The screen is split in two and the left and right screens display the following im ages:
Left
screen
Image supplied to the last selected input s ource, VGA (C OMP UTE R1), 5BNC (COMPUTER2), DVI, HDMI or
SDI (for PHWU-81B only)
Right
screen
Image supplied to the last selected input source, VIDEO or S-VIDEO
Important
• When you press the M EN U key, the screen is displayed in the normal mode.
• Also, when you change the input source, the screen is displayed in the normal mode.
• In the split mode, the p icture quality settings of the input source in the normal m ode to be displayed on the left screen are
reflected on the entire screen.
• When no signal is input, a blue sc reen is displayed.
• When you input an interlace signal to the left screen, the displayed image may shake up and down slightly, but t
his is not a
malfunction.
• When you display 60-Hz and 50-Hz video signals at the same time, motion images may not be displayed properly. In this c ase,
set VERT. S YN C. of USER in the SIGNAL menu to OFF for the left screen.
• You cannot use the split mode un less a signal is being input.
• Displaying the screen split in two may take some time depending on the signal.
To change the input source of the left or right screen:
• To change the input s ource of the left screen, press the ◄ key on the remote control. Each time the the ◄ keyispressed,the
input so urce setting chang es in order o f VGA (C OMPUTER 1) → 5BNC (COMPUTER 2) → DVI → HDMI → SDI (for PHWU-
81B only) → VGA (COMPUTER 1) ....
• To change the input s ource of the right screen, press the ► key on the remote control. Each time the the ► keyispressed,the
input source setting changes in order of VIDEO → S-VIDEO → VIDEO ....
9.3 Picture in Picture (PIP)
for PHXG- 9 1B o nl y
About Picture in Picture
One of the special features of this projector is the picture-in-picture (PIP) m ode. The PIP mod e allows you to view the imag es from
different sources at the same time.
While viewing the image from the VGA (COMPUT ER1), 5BNC (COMP UT ER2), DVI, or HDM I input source, you can display the
image from the VIDEO or S -VIDEO input source as a sub image.
A
Image 9-6
A Sub image
To use the PIP m ode:
1. Display the INSTALLATION 1 menu in the ADVANCED MENU.
2. Select PIP.
3. Press ENTER key.
Sub image is displayed.
R5905597 PHXX SERIES 28/01/2014
87