Filter
Top Products
Register the Favorite Scan Settings Using ControlCenter2 (CUSTOM SCAN) (Macintosh)
file:///C|/Documents%20and%20Settings/mcampbell.AM/My%20Documents/ADS2000solutions/chapter3_6.html[3/11/2013 10:25:57 AM]
Brightness Adjust the setting (0 to 100) to get the best image. The
default value of 50 represents an average and is
usually suitable for most images. You can set the
Brightness level by dragging the slider to the right or
left to lighten or darken the image. If the scanned
image is too light, set a lower Brightness level and
scan the document again. If the image is too dark, set
a higher Brightness level and scan the document
again.
Yes Yes Yes Yes
Contrast Adjust the setting (0 to 100) to get the best image. The
default value of 50 represents an average and is
usually suitable for most images. You can increase or
decrease the contrast level by moving the slider to the
right or left. An increase emphasizes dark and light
areas of the image, while a decrease reveals more
details in gray areas.
Note
The Contrast setting is only available when
setting Scan Type to Auto, Gray (Error
Diffusion), True Gray or 24bit Color.
Yes Yes Yes Yes
Duplex(two-
sided) Scanning
If you check this box, the machine scans both sides of
the document. When using the automatic 2-sided
(duplex) scan feature, you must select Long-edge
binding or Short-edge binding depending on the
layout of your original to make sure that the data file
created appears correctly in the scanned document.
Note
The 2-sided (duplex) scanning feature is available
with lengths up to Legal size.
Yes Yes Yes Yes
Restore Defaults Restore all settings to their factory default values. Yes Yes Yes Yes
Continuous
Scanning
You can scan multiple batches of documents and put
them together into one data file. After the first batch of
documents is scanned, click Continue for additional
pages or Finish. This operation enables you to scan
more sheets than the maximum capacity of the
document feeder.
Yes Yes Yes Yes
Carrier Sheet
Mode
You can scan the following documents using the
Carrier Sheet. For this mode, you can select any
setting other than Auto from the Document Size drop-
down list.
• Large-sized Documents (A3, B4 and Ledger)
Fold the document in half and insert it in the Carrier
Sheet for 2-sided (duplex) scanning, then both front
and back pages will be combined into a single page.
Yes Yes Yes Yes