Filter
Top Products
Change Scan Settings
file:///C|/Documents%20and%20Settings/mcampbell.AM/My%20Documents/ADS2000solutions/chapter4_5_8.html[3/11/2013 10:23:43 AM]
To save the document as a password-protected PDF, select Secure
PDF from the File Type(Gray) drop-down list, and then enter the
password (the default value is “0000”) in the Password for Secure
PDF field.
File Type(Color) Lets you select a file type for scanning in color.
Select a file type you want to use for the scanned data.
Note
To save the document as a password-protected PDF, select Secure
PDF from the File Type(Color) drop-down list, and then enter the
password (the default value is “0000”) in the Password for Secure
PDF field.
File Type(Auto) Lets you select a file type when you have selected Auto from the Scan
Type drop-down list. Select a file type you want to use for the scanned
data.
Note
To save the document as a password-protected PDF, select Secure
PDF from the File Type(Auto) drop-down list, and then enter the
password (the default value is “0000”) in the Password for Secure
PDF field.
Resolution You can select a scanning resolution from the Resolution drop-down list.
Higher resolutions take more memory and transfer time, but produce a
finer scanned image.
Document Size Lets you choose from a selection of preset scan sizes.
Auto Deskew Corrects the skew (within 5 degrees) of the scanned data.
Blank Page Skip Removes blank pages of the document from the scanning results.
Multifeed Detection Uses a ultrasonic sensor to detect when a multifeed has occurred. When
this function detects a multifeed, confirm that the data scanned before the
multifeed has been saved, and then start scanning again at the next page
or the beginning of the document.
Note
The data scanned before the multifeed occurred is saved if you have
selected JPEG as the file type.
Duplex Scanning If you select On : Long-edge binding or On : Short-edge binding, the
machine scans both sides of the document. You must select On : Long-
edge binding or On : Short-edge binding depending on the layout of
your original to make sure that the data file created appears correctly in
the scanned document.
File Name Enter a prefix for the file name (up to 64 characters). The file name will be
the prefix you registered and sequential number. If the prefix is not