Filter
Top Products
6-37
Cisco Router and Security Device Manager 2.5 User’s Guide
OL-4015-12
Chapter 6 Edit Interface/Connection
Add a G.SHDSL Connection
DSL Connections
This field displays all of the G.SHDSL connections currently configured on this
controller. To configure a new G.SHDSL connection, click Add. This displays the
Add a G.SHDSL Connection page, letting you configure the new connection. To
edit an existing G.SHDSL connection, choose the connection in this field and
click Edit. This also will display the Add a G.SHDSL Connection page, letting
you edit the connection configuration. To delete a connection, choose the
connection in this field, and click Delete.
Add a G.SHDSL Connection
This window enables you to create or edit a G.SHDSL connection.
Encapsulation
Select the type of encapsulation that will be used for this link.
• PPPoE specifies Point-to-Point Protocol over Ethernet encapsulation.
• PPPoA specifies Point-to-Point Protocol over ATM encapsulation.
• RFC 1483 Routing (AAL5 SNAP) specifies that each PVC can carry
multiple protocols.
• RFC 1483 Routing (AAL5 MUX) specifies that each PVC carry only one
type of protocol.
If you are editing a connection, the encapsulation is shown, but not editable. If you
need to change the encapsulation type, delete the connection, and recreate it,
using the encapsulation type you need.
Virtual Path Identifier
The virtual path identifier (VPI) is used in ATM switching and routing to identify
the path used for a number of connections. Obtain this value from your service
provider.
If you are editing an existing connection, this field is disabled. If you need to
change this value, delete the connection and recreate it using the value you need.