42-25
Cisco Router and Security Device Manager 2.5 User’s Guide
OL-4015-12
Chapter 42 Viewing Router Information
Traffic Status
QoS
The QoS Status window allows you to monitor the performance of the traffic on
QoS configured interfaces (see Associating a QoS Policy With an Interface). This
window also allows you to monitor bandwidth utilization and bytes-sent for
interfaces with no QoS configuration. Monitoring inbound traffic on QoS
interfaces shows the statistics only at a protocol level. Protocol-level statistics for
non-QoS interfaces are collected for traffic in both directions.
This window allows you to monitor the following statistics:
• Bandwidth utilization for Cisco SDM defined traffic types
–
Bandwidth utilization per class under each traffic type
–
Bandwidth utilization for protocols under each class
Bandwidth utilization is shown in Kbps.
• Total incoming and outgoing bytes for each traffic type
–
Incoming and outgoing bytes for each class defined under the traffic type
–
Incoming and outgoing bytes for each protocol for each class
If the value is more than 1,000,000, then the graph may show the bytes as a
multiple of 10^6. If the value is more than 1,000,000,000, then the graph may
show the bytes as a multiple of 10^9.
• Packets dropped statistics for each traffic type
Interface—IP/Mask—Slot/Port—Description
This area lists the interfaces with associated QoS policies, their IP addresses and
subnet masks, slot/port information if applicable, and available descriptions.
Select the interface that you want to monitor from this list.
View Interval
Select the interval at which statistics should be gathered:
• Now—Statistics are gathered when you click Start Monitoring.
• Every 1 minute—Statistics are gathered when you click Start Monitoring,
and refreshed at 1-minute intervals.