Filter
Top Products
Chapter 7 Wide Area Application Services
Configuring a WAAS Connection
7-2
Cisco Router and Security Device Manager 2.5 User’s Guide
OL-4015-12
This chapter contains the help topics for the WAAS configuration screens and
contains the following sections:
• Configuring a WAAS Connection
• WAAS Reference
Configuring a WAAS Connection
You must have a WAAS network interface module installed on the router in order
to configure WAAS.
Complete the following steps to configure a WAAS connection:
Step 1 If you want to review the Cisco IOS CLI commands that you send to the router
when you complete the configuration, go to the Cisco SDM toolbar, and click Edit
> Preferences > Preview commands before delivering to router. The preview
screen allows you to cancel the configuration if you want to.
Step 2 In the Cisco SDM toolbar, click Configure.
Step 3 In the Cisco SDM toolbar, click Interfaces and Connections.
Step 4 Click the NM WAAS tab, next to the Edit Interface/Connection tab.
Step 5 Click Edit Settings to configure the router for the WAAS network module.
a. Enter the required information in the Integrated Services Engine tab. See
Integrated Service Engine for more information
b. Click WCCP, and enter the required information in the WCCP tab. See
WCCP for more information.
Step 6 Click OK to return to the NM WAAS tab.
Step 7 If you checked Preview commands before delivering to router in the Edit
Preferences screen, the Cisco IOS CLI commands that you are sending are
displayed. Click Deliver to send the configuration to the router, or click Cancel
to discard it. If you did not make this setting, clicking OK sends the configuration
to the router.
Step 8 In the Tools menu, click Telnet.
Step 9 Enter the router username and password.