Filter
Top Products
114
| Understanding the System Menus
❚
Admin Settings >
USB Settings
Use the USB Settings menu to change printer settings affecting a USB port.
❚
Admin Settings > USB Settings >
USB Port
NOTE:
• USB Port setting is available only for the USB port on the rear of the printer.
Specifies whether to enable the USB Port setting, which enables the USB Port. The
change becomes effective after the printer is turned off and then on again.
❚
Admin Settings > USB Settings >
PS Data Format
Specifies PostScript 3 Compatible communication protocol for a parallel interface. You
can configure the PS Data Format settings for the wired network. The change becomes
effective after the printer is turned off and then on again.
❚
Admin Settings > USB Settings >
Job Time-out
Specifies whether to enable the Job Time-out feature, which specifies the amount of
time the printer waits for data to arrive from the computer. The print job is canceled if
the time-out time is exceeded.
Default Settings
Use Default Settings menu to modify the Copy, Scan, or Fax menu defaults.
To display the Default Settings menu, press the (Information) button, and then
tap the Tools tab.
❚
Default Settings >
Copy Defaults
Modifies the Copy menu defaults. Copy Defaults allows you to configure the
following items in addition to the items under the Copy menu. See "Copy."
❚
Default Settings > Copy Defaults >
Auto Exposure Level
Sets the default background suppression level to Normal/High/Highest.
Auto Used when auto-detecting the PostScript 3 Compatible
communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP Used when the communication protocol supports both ASCII and
binary data to switch between them according to the specified
control code.
Binary Used when no special processing is required for data.