Filter
Top Products
Understanding the System Menus |
97
❚
Admin Settings > Network > Advanced Settings >
PS Data Format
Specifies PostScript 3 Compatible communication protocol for a parallel interface, you
can configure the PS Data Format settings for the wired network. The change
becomes effective after the printer is turned off and then on again.
❚
Admin Settings > Network >
Reset LAN
Initializes wired network data stored in non-volatile memory (NVM). After executing this
setting and restarting the printer, all wired network settings are reset to their default
values.
❚
Admin Settings > Network >
Delete All Certificates
Deletes all certificates of the printer. After executing this setting and restarting the
printer, all certificates are deleted.
❚
Admin Settings >
Fax Settings
Use the Fax Settings menu to configure the basic fax settings.
❚
Admin Settings > Fax Settings >
Fax Line Settings
Configures basic settings for the fax line.
❚
Admin Settings > Fax Settings > Fax Line Settings >
Fax Number
Sets the fax number of the printer to be printed on the header of a fax message.
NOTE:
• Make sure to specify Fax Number before using Junk Fax Setup.
❚
Admin Settings > Fax Settings > Fax Line Settings >
Country
Selects the country where the printer is used.
❚
Admin Settings > Fax Settings > Fax Line Settings >
Fax Header Name
Sets the sender name to be printed on the header on faxes.
Auto Used when auto-detecting the PostScript 3 Compatible
communication protocol.
Standard Used when the communication protocol is in ASCII interface.
BCP Used when the communication protocol is in binary format.
TBCP Used when the communication protocol supports both ASCII and
binary data to switch between them according to the specified
control code.
Binary Used when no special processing is required for data.