Filter
Top Products
Understanding the System Menus |
95
❚
Admin Settings > Network > Ethernet >
IPsec
NOTE:
• IPsec is displayed only when IPsec is enabled on Dell Printer Configuration Web Tool.
Disables IPsec.
❚
Admin Settings > Network > Ethernet >
Connection Speed
NOTE:
• The Connection Speed setting is available only when the printer is connected to the wired
network.
Specifies the communication speed and the duplex settings of Ethernet. The change
becomes effective after the printer is turned off and then on again.
Get IP Address AutoIP Sets the IP address automatically. A random value in the
range of 169.254.1.0 to 169.254.254.255 that is not
currently in use on the network is set as the IP address.
The subnet mask is set as 255.255.0.0.
BOOTP Sets the IP address using BOOTP.
RARP Sets the IP address using RARP.
DHCP Sets the IP address using DHCP.
Panel Use this option when you want to set the IP address
manually on the operator panel.
IP Address When an IP address is being set manually, the IP is
allocated to the printer using the format
nnn.nnn.nnn.nnn. Each octet that makes up
nnn.nnn.nnn.nnn is a value in the range of 0 to 254. 127
and any value in the range of 224 to 254 cannot be
specified for the first octet of a gateway address.
Subnet Mask When an IP address is being set manually, the subnet
mask is specified using the format nnn.nnn.nnn.nnn. Each
octet that makes up nnn.nnn.nnn.nnn is a value in the
range of 0 to 255.255.255.255.255 cannot be specified as
the subnet mask.
Gateway Address When an IP address is being set manually, the gateway
address is specified using the format nnn.nnn.nnn.nnn.
Each octet that makes up nnn.nnn.nnn.nnn is a value in
the range of 0 to 254. 127 and any value in the range of
224 to 254 cannot be specified for the first octet of a
gateway address.
Auto
10BASE-T Half
10BASE-T Full
100BASE-TX Half
100BASE-TX Full
1000BASE-T Full