MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS
CWCALL ssss Mode: Amtor Default: blank
Where "ssss" are 15 characters sent as CW when you issue the ID character. The "ssss" text
is sent following the QRA ("The name of my station is ______") signal.
CWidmode nn: 0<=nn<=255 Mode: Pactor Default 0
Should CW identification be required, the MFJ-1278B now supports 8 CW identification
modes. Seven automatic modes are selected by the bit-mapped CWIDMODE parameter.
Bit positions within the CWIDMODE parameter enable timed cw id, cwid on incoming
events, cwid on outgoing events, and any combination of the three for a total of 7 modes.
The timed mode requires some explanation. The counter controlling the transmission of the
timed CWID must be initially started at the beginning of each link with either the manual
"ID" command or one of the initial CWIDMODE features selected by CWIDMODE bits 1
or 2. A fully automatic CW ID is achieved by setting CWIDMODE to 3. Reduced levels of
automation are selected by other combinations. The eighth mode is manual cwid. Invoke
manual CWID by issuing the "ID" command. Also see IDTIME
The CWIDMODE command in Pactor is very complex and provides several combinations of
CWID. Below is an example of how CWIDMODE functions:
CWID/
MODE
On
Calling
On
Connect
On
Disc.
Man./
Auto
Comments
1 Man.
Only
Mode 1 is manual ID only
2 IRS IRS
3 ISS,IRS IRS IRS Auto
ISS,
ISR
Auto ID interval dependent on the
IDTIME setting
4 ISS ISS If ISS does changeover, and new ISS
disconnects, then the new ISS will ID
5 ISS ISS Auto
ISS
only
If ISS does changeover, then previous
ISS auto ID is Disabled
6 ISS IRS ISS,
IRS
Upon reciept of disconnect from ISS
and the disconnect appears on IRS
screen, the IRS will ID. After ID
from IRS, the ISS will ID
7 ISS, IRS IRS IRS,
ISS
Auto
ISS,
IRS
When ISS sends changeover, new ISS
AUTO ID enabled. Auto ID for
previous ISS is disabled. Disconnects
are handled the same as Mode 6