Filter
Top Products
MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS
MYHIERAD Text Mode: Mailbox Default: " "
Text Any combination of characters and spaces, up to 60 characters in length.
You may use this parameter to generate a customized "@:" portion of the tagline your TNC
will insert in forwarded messages. If MYHIERAD is blank, the default @ portion will read
"@:<mymcall>". It is suggested that you insert your hierarchical address, location, and
zip/postal code in this parameter. Example: MYHIER for N2WX in Sebastian Florida in the
Melbourne LAN at zipcode 32958, using N5AUV as the home bbs, would be entered like
this:
cmd: MYHIER N5AUV.#MLBFL.FL.USA.NA [N2WX User/Sebastian] Z:32958
and the tagline would look like this
"R:920801/1200 @:N5AUV.#MLBFL.FL.USA.NA [N2WX User/Sebastian] Z:32958 #:8"
MYMCALL [callsign] Mode: Mailbox Default: blank
The MYMCALL command specifies the dedicated callsign for the Packet Mailbox. If
MYMCALL equals MYCALL, the TNC responds to incoming connections in mailbox
mode. When there is no callsign put in MMcall, the mailbox is inaccessible to remote users.
MYSELCAL "ssss" Mode: AMTOR Default: blank
The MYSELCAL command specifies the AMTOR SELCAL that the MFJ-1278B responds
to in AMTOR Mode A operations. See section "Mode A: Setup" for information on
selecting a SELCAL for your station, based on your amateur callsign.
Note that your MFJ-1278B will not respond to mode A "ARQ" calls unless MYSELCAL is
set up.