Epson MFJ-1278B Switch User Manual


 
MFJ-1278B MULTI-MODE BASIC OPERATION
is proper Pactor etiquette. If you access your Mailbox via the SYsop command, then
you must issue a CTRL-C to exit the Mailbox and return to command mode. The
SYSOP mode is accessed through the Packet mailbox, as mentioned earlier in this
section. The command prompt will indicate the stream you are on. The command
prompt may look like this:
|Acmd: where |A indicates that you are on packet stream A.
To re-enter the Pactor mailbox you would type the following from the cmd: prompt:
PACTOR <ENTER>
This is the only way the remote users can access your Mailbox.
Mailbox Messages
You have new mail!
Upon accessing the mailbox this message will appear if there are any new messages are
addressed following the last time you logged into the mailbox.
You have mail!
Upon access to a mailbox, this message will appear if there are messages addressed to you.
?EH
This message occurs when a command issued is not understood by the mailbox. This could
be out of range slot number, missing slot number where one is required, or bad command.
Cannot, not yours
This message occurs when a remote user attempts to kill a message which is not his, or he
tries to read personal message by or for someone else.
?Mailbox full
This message occurs when either all of the available slots are full, or the actual message
space is full. Messages must be killed to recover from this error.
Not found
This message occurs when one attempts to read or kill a non-existent message from an empty
slot.
None found
A parameterless Kill or Read command did not find any messages addressed to the user.
No mail