Epson MFJ-1278B Switch User Manual


 
MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS
MCOM ON/OFF Mode: Packet Default: OFF
Parameters:
ON Connect, disconnect, UA, and DM frames are monitored.
OFF Only information frames are monitored.
This command enables monitoring of connect and disconnect frames when MONITOR is
ON.
When MCOM is OFF, only I frames (packets containing user information) will be
displayed. When MCOM is ON four protocol packets will also be displayed. Connect,
disconnect, UA, and DM packets that are monitored are indicated by <C>, <D>, <UA>, and
<DM>, respectively. As with other monitor commands, the stations monitored are
determined by BUDLIST and LCALLS.
Path for SABM received while in link-setup state is not checked.
MCON ON/OFF Mode: Packet Default: ON
Parameters:
ON Monitor mode remains active when MFJ-1278B is connected.
OFF Monitor mode is off while the MFJ-1278B is connected.
If MCON is ON, the MONITOR command will enable monitoring while your MFJ-1278B
is connected to another TNC. If MCON is OFF, the display of monitored packets is
suspended when a connect occurs, and is resumed when the TNC is disconnected.
If you want to see all packets displayed when you are not connected but have such display
suppressed when you connect to another station, you should set MCON OFF.