MFJ-1278B MULTI-MODE APPENDIX H COMMAND SUMMARY
Command Paramete
r
Default Mode Function Page
RETries
nnn I-command Pactor Specifies number of error packet cycles. 6-104
RETRY
n 10 Packet Allows retransmission of frames that are
not acknowledged.
6-104
REVFLIM
call-n blank M-Packet Callsigns of BBS to enable reverse-
forwards.
6-105
RFE
ON|OFF off AMTOR Will continue to retry until a QRT is
received.
6-105
RINV
ON|OFF off AMTOR Controls the incoming received signal to
be inverted before detection/processing
occurs.
6-105
RXBLOCK
ON|OFF off Packet Determines whether the information will
be sent in standard or block format.
6-106
RXBRIGHT
n 4 SSTV/FAX Determines brightness and contrast of
SSTV or FAX pictures
6-107
RXCAL
-- I-command All Generates test signals that are used by the
internal tuning software to align the
demodulator circuit.
6-108
RVFALWAY
ON|OFF on M-Packet Initiates forwards and reverse of all
forwardable messages.
6-110
RXINVERT
ON|OFF off RTTY/ASCII Inverts the mark and space tones. 6-110
SCREENLN
n 0 All Used to properly format terminal output. 6-110
SELCALL
ssss I-command AMTOR Initiate a mode L "SELCALL" broadcast. 6-111
SENDPAC
n $0D (CR) Packet Selects the character that will force a
packet to be sent in CONVERSE mode.
6-111
SERIALNO
0-65535 0 CW Used for contest serial numbering. 6-111
SETUP
n I-command All Used to set the mode and baud rate.
Similar to the MODE command.
6-112
SFNL
ON|OFF on AMTOR Controls whether the 1278B adds a new
line character to "+?" and WRU.
6-112
SLOTS
nn 3 Packet Determines how many sides are on the
slot time dice.
6-113
SOLF
ON|OFF on AMTOR Determines whether only <lf> characters
from the AMTOR receiver are sensed as
newline characters.
6-113
SRXALL
ON|OFF on AMTOR Causes the MFJ-1278B to print all
receivable mode S transmissions.
6-114
START
n $11 (^Q) All Selects the user restart character. 6-114
STatus
-- I-command Pactor Displays debug information helpful in
troubleshooting Pactor problems.
6-114
STATUS
-- I-command AMTOR Returns useful diagnostic information for
helping us help you with your problems.
6-115
STOP
n $13 (^S) All Selects the user stop character. 6-115
STREAMCA
ON|OFF off Packet Used to enable the display of the
connected to station after the stream
identifier.
6-116
STREAMDB
ON|OFF off Packet Used to display received
STREAMSWITCH characters by
6-117