Filter
Top Products
MFJ-1278B MULTI-MODE APPENDIX H COMMAND SUMMARY
Command Paramete
r
Default Mode Function Page
MRPT
ON|OFF on Packet Affects the way monitored packets are
displayed.
6-80
MSPEED
nn 20 CW Sets the operational speed which the MFJ-
1278B will use for CW.
6-80
MSTAMP
ON|OFF off Packet Enables the time stamping of monitored
packets.
6-81
MTIMEOUT
0-250 30 M-Packet Mailbox connect will timeout after a time
set by this command.
6-81
MULTIFAX
ON|OFF off FAX Enables multi-level FAX transmitting and
receiving.
6-82
MYCALL
call nocall Packet Sets the callsign of the MFJ-1278B. 6-82
MYcall
callsign MFJPACTR Pactor Your Pactor amateur callsign 6-83
MYALIAS
call-n blank Packet Specifies an alternate callsign for use as a
digipeater only.
6-83
MYDLCNUM
0-254 0 Host Sets the DLC number for Host Mode. 6-83
MYHIERAD
nnnn text M-Packet Sets the heiarcal address text sent by a
Mailbox forward.
6-84
MYMCALL
call nocall M-Packet Dedicated mailbox callsign. 6-84
MYSELCAL
ssss blank AMTOR Tells the MFJ-1278B what SELCALL
your station should respond to.
6-84
NAVTEX
-- I-command NAVTEX Allows you to receive NAVTEX signals. 6-85
NAVSTN
xxxxx all NAVTEX Allows you to receive certain NAVTEX
stations.
6-85
NAVMSG
x all NAVTEX Allows you to receive certain NAVTEX
messages.
6-86
NEWMODE
ON|OFF off Packet Selects the way the MFJ-1278B behaves
when connections are made and broken.
6-87
NO200
ON/OFF OFF Pactor Enables or inhibits 200 baud Pactor mode. 6-88
NODEFORW
-- I-command M-Packet Similar to Forward command but with
callsign+ up to 8 vias.
6-88
NODEPATH
-- I-command M-Packet Commands connected node by Nodeflow
to link with the receiving BBS.
6-89
NOMODE
ON|OFF off Packet Determines if the MFJ-1278B will switch
manually or automatically to command
mode.
6-89
NUCR
ON|OFF off Packet Causes transmission of <null> characters,
producing a delay following any <cr> sent
to the terminal.
6-90
NULF
ON|OFF off Packet Same as NUCR, instead of <cr> it sends
a delay after a <lf>.
6-90
NULLS
n 0 Packet Used in conjunction with NUCR and
NULF, and specifies how many <null>
characters are sent.
6-90
OK
-- I-command ASA Use with ASA command to accept the
analyzed signal.
6-91
OMLC
ON|OFF off AMTOR Instructs the MFJ-1278B to convert all
characters, except those echoed, to their
6-91