Filter
Top Products
Gentran:Server for Windows User’s Guide Gentran:Server for Windows – November 2005
Using Interchanges Resending Interchanges
7 - 19
Resending a
specific
interchange
To resend a specific outbound interchange, complete the following steps:
Resend process The following describes the system process that occurs when you resend an
interchange:
Step Action
1
From the appropriate area of The Desk, select Interchanges.
System response
The system displays the Interchanges Browser.
2
Select the outbound interchange that needs to be resent.
3
From the Document menu, select Resend.
System response
The system displays the Gentran:Server for Windows dialog box.
4
Click Yes to start the transmission session.
Stage Description
1
When the resend command is executed, the system first determines if
it is a TRADACOMS interchange. If the interchange is
TRADACOMS, the system increments the current version number in
the FIL segment by one. After this update, the interchange is resent in
the same manner as all other interchanges.
2
Communication is established with the remote end. The status of the
message is updated based on the success or failure of the
communications session.
◗ If communication fails because there is no mailbox set up or the
Mailbox service is not started, the interchange and documents are
left in a Ready to send status.
◗ If communication fails because there is no modem, the
interchange and documents are left in a Queued status.
Note
No user action is required at this point. Interchanges that failed to
send are automatically sent as part of the next transmission session.
3
The documents are moved to the Out Drawer Browser and the
interchange status is set to Sent.