Filter
Top Products
This soft copy for use by IBM employees only.
Windows NT Server Setup
=======================
Setup has recognized the following mass storage devices in your
computer:
Adaptec AHA-294X-394X/AIC-78XX SCSI Controller
* To specify additional SCSI adapters, CD-ROM drives, or special
disk controllers for use with Windows NT, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage device for use with Windows NT, press ENTER.
S=Specify Additional Device ENTER=Continue F3=Exit
Figure 56. Disk Controllers Detected During Installation. This panel applies to the PC
Servers 325, 330 and 704; other servers are similar.
5.3.3 Specifying Additional Adapters
If the listed disk controllers do not include all the disk controllers in use in your
server, continue on here; otherwise skip to 5.3.5, “System Analysis” on page 88.
There are two major reasons why your disk controller may not have been
automatically detected:
1. You have more than one controller (for example, an integrated controller and
an adapter in a slot) and the controller detected was not the one you have
your disks attached to.
2. You have an adapter for which the driver required was not included on the
NT 4.0 CD-ROM (for example, the ServeRAID adapter).
In either instance, you will need to press S when the panel shown in Figure 56 is
displayed.
84 PC Server and Windows NT Integration Guide