Filter
Top Products
NDA-24296 CHAPTER 3
Page 197
Revision 1.0
PH-CK16-A
Phase Lock Oscillator
The key setting of
“
SW01
”
differs depending on the mounting location.
[Mounted in ISWM of IPX-U/IPX-UMG System or TSWM of 4-IMG System]
Note:
When this card is used in the 4-IMG or ISWM of the IPX-U/IPX-UMG system, specify the clock source
(DCS or DTI) according to the clock network configuration for the office.
Note 1:
This standard setting is applicable when this card is mounted in ISWM of the IPX-U/IPX-UMG system.
SWITCH
NAME
SWITCH
NO.
SETTING
STANDARD
SETTING
MEANING
SW01
1
ON
×
Note 1
Clock subordinate office.
OFF Clock source office.
2
ON Digital Clock Supply route zero (DCS 0) is used.
OFF
×
Note 1
Digital Clock Supply route zero (DCS 0) is not used.
3
ON Digital Clock Supply route one (DCS 1) is used.
OFF
×
Note 1
Digital Clock Supply route one (DCS 1) is not used.
4
ON
8 KHz of Frame Head signals are extracted from the DCS
signals (which is composed of 64 KHz + 8 KHz).
OFF
×
Note 1
8 KHz of Frame Head signals are not extracted from the DCS
signals (which is composed of 64 KHz + 8 KHz).
5
ON
When clock source failure has occurred in all supply routes, the
PLO outputs the original clock of the internal oscillator.
OFF
×
Note 1
When clock source failure has occurred, the PLO keeps on
outputting the current phase clock.
6
ON
This circuit card is used with SYNC (PA-CK16) card and 5m
Frame Pulse (FP) is supplied by the SYNC card.
OFF
×
Note 1
This circuit card is not used with SYNC (PA-CK16) card.
7
ON A-law CODEC is used for Music-on-Hold.
OFF × µ-law CODEC is used for Music-on-Hold.
8OFF × Fixed to “OFF” (Not used).