Filter
Top Products
NDA-24296 CHAPTER 2
Page 29
Revision 1.0
SN1695 CPRBF-A
CPU Board
Note:
The segment spinning indication shows a processing status has completed successfully, or “E” indicates
the processing failed.
LAMP
NAME
DESCRIPTION
STATUS
(DSP)
Two sets of “7-segment LED” show the CPR processing status. The CPR processing status is determined by the
SENSE switch settings, and the new processing status starts when the CPURST switch is pressed. The 7-segment
LED indication on each CPR processing status is listed below.
SENSE
STATUS
DESCRIPTION
LEFT RIGHT
1
Not used
“F”
“c”
“d”
1. When Program Install
The HD in the CPR is initialized and the program is installed. (These three processes
execute)
“F”indicated during HD format.
“c”indicated when copying data from FD to HD
“d” indicated while making the directory on the HD
Not used “1”
2. When Program Load
After program installation, the program should be transferred from the HD to
memory.
“1” is indicated during this process.
2
“0-9”“0-9”
3. On-line active CPR
The active CPR which is in ON LINE status indicates the CPU occupancy rate by
percentage. (00-99%)
Not used
“S”
“b”
“y”
4. On-line stand-by CPR
The stand-by CPR which is in ON LINE status indicates “S,” “b,” “y”
Not used
5. Program & Office data load
“1”indicated during the Program and Office data transfer from the HD to the
memory
“0” indicated during the Office data load
3Not used “c”“c”indicated when copying the data from FD to HD
4Not used “d”“d”indicated while making the directory on the HD
5Not used
The CPR is starting-up with ON LINE (OAI memory clear restart).
“1”indicated during the Program load.
“0”indicated during the process.
6Not used “F”“F” indicated during HD format.
CNot used “H”
The CPR is starting-up OFF LINE.
“H”indicated during the ROM data loading.
“1”
“0”
“1”
“0”
Segment Spinning Indication