Filter
Top Products
NDA-24296 CHAPTER 3
Page 419
Revision 1.0
PA-8RSTM
Register Sender Trunk
4. Lamp Indications
Lamp indications for this circuit card are shown in the table below.
5. Switch Settings
Standard settings for various switches on this circuit card are shown in the table below.
LAMP NAME COLOR STATE
OPE Green Remains lit while this circuit card is operating.
BLR0
BLR7
Red Lights when the corresponding circuit has received the selective signals.
Flash Flashes (60 IPM) while the corresponding circuit is in Make-busy state.
OFF Remains off when the corresponding circuit is idle.
BLS0
BLS7
Red Lights when the corresponding circuit has sent the selective signals.
Flash Flashes (60 IPM) when the corresponding circuit is in Make-busy state.
OFF Remains off while the corresponding circuit is idle.
SWITCH
NAME
SWITCH
NO.
SETTING
STANDARD
SETTING
MEANING
MB
UP Circuit card Make-busy.
DOWN × Circuit card Make-busy cancel.
MBR0~3
(SW01)
0
ON Register Make-busy of the corresponding circuit.
OFF × Register Make-busy cancel of the corresponding circuit.
1
ON Register Make-busy of the corresponding circuit.
OFF × Register Make-busy cancel of the corresponding circuit.
2
ON Register Make-busy of the corresponding circuit.
OFF × Register Make-busy cancel of the corresponding circuit.
3
ON Register Make-busy of the corresponding circuit.
OFF × Register Make-busy cancel of the corresponding circuit.
MBR4~7
(SW03)
4
ON Register Make-busy of the corresponding circuit.
OFF × Register Make-busy cancel of the corresponding circuit.
5
ON Register Make-busy of the corresponding circuit.
OFF × Register Make-busy cancel of the corresponding circuit.
6
ON Register Make-busy of the corresponding circuit.
OFF × Register Make-busy cancel of the corresponding circuit.
~~