Filter
Top Products
Safety
WorkCentre 6400 Multifunction Printer
User Guide
12
Electrical Safety
Warning: Do not push objects (including paper clips or staples) into slots or openings on the
product. Making contact with a voltage point or shorting out a part could result in fire or electrical
shock.
Warning: Do not remove the covers or guards that are fastened with screws unless you are
installing optional equipment and are specifically instructed to do so. Power should be OFF when
performing these installations. Disconnect the power cord when removing covers and guards for
installing optional equipment. Except for user-installable options, there are no parts that you can
maintain or service behind these covers.
The following are hazards to your safety:
• The power cord is damaged or frayed.
• Liquid is spilled into the product.
• The product is exposed to water.
If any of these conditions occur, do the following:
1. Turn off the product immediately.
2. Disconnect the power cord from the electrical outlet.
3. Call an authorized service representative.
Laser Safety
This printer complies with laser product performance standards set by governmental, national, and
international agencies and is certified as a Class 1 Laser Product. The printer does not emit hazardous
light because the beam is totally enclosed during all modes of customer operation and maintenance.
Warning: Use of controls, adjustments, or performance of procedures other than those specified in
this manual can result in hazardous radiation exposure.
Power Cord
• Use the power cord supplied with your product.
• Plug the power cord directly into a properly grounded electrical outlet. Make sure each end of the
cord is securely connected. If you do not know if an outlet is grounded, ask an electrician to check
the outlet.
• Do not use a ground adapter plug to connect the printer to an electrical outlet that does not have
a ground connection terminal.
Warning: Avoid the potential of electrical shock by ensuring that the product is properly grounded.
Electrical products may be hazardous if misused.
• Do not use an extension cord or power strip.
• Verify that the product is plugged into an outlet that is capable of providing the correct voltage
and power. Review the product’s electrical specification with an electrician if necessary.