Filter
Top Products
Maintenance
WorkCentre 6400 Multifunction Printer
User Guide
172
11. Scanner calibration from the document glass is complete. The scanner must now be calibrated
from the document feeder. Remove the scanner calibration page from the document glass, and
place three blank sheets of paper (letter or A4 size)in the document feeder. Place the calibration
page on top of the three sheets. Adjust the paper guides to fit against the calibration page.
Note: The paper guides should be adjusted to fit against the paper. If the page is misaligned, the
calibration procedure will fail.
12. On the control panel, select Document Feeder Registration, then press the Start button to scan
the calibration page.
13. Wait for the scan to be completed, then select one of the following options:
• If the control panel indicates Success, select Close. The calibration procedure is complete.
• If the control panel indicates Failure, select Close, then repeat Steps 12–13.
Note: When you are finished calibrating the scanner, please return the calibration page to Xerox
with the defective scanner or document feeder.
For more information about calibrating the scanner, see the Online Support Assistant at
www.xerox.com/office/WC6400support.
6400
-
174