Zebra Technologies 3ULQWHUV Printer User Manual


 
18 Zebra XiIIIPlus Users Guide
Printer Setup and Calibration
Before You Begin
7RSULQWDFRQILJXUDWLRQODEHOFRPSOHWHWKHVHVWHSV
1. Connect the power cord to the printer.
The power connection is at the back of the printer.
2. To confirm the power connection, turn the printer On (I ).
3. If 35,17(55($'<displays on the front panel LCD, go to the next step.
If 35,17(55($'<does not display, go to Troubleshooting on page 120.
4. Turn the printer Off (O).
5. Press and hold CANCEL while turning the printer On (I ) .
6. After the DATA light turns off (approximately five seconds), release CANCEL.
Caution • For personal and equipment safety, always use an approved three-
conductor power cord specific to the region or country intended for installation.
This cord must utilize and IEC-320 female connector, and the appropriate region-
specific three-conductor grounded plug configuration.