Zebra Technologies 3ULQWHUV Printer User Manual


 
Labels and Print Modes
Print Mode Choices
Zebra XiIIIPlus Users Guide 29
3HHO2II0RGH
Peel-Off Mode advances one label at a time. The printer does not print another label
until the first label is removed. The TAKE LABEL light flashes until the label is
removed. The liner is wound on the rewind spindle, but the rewind plate is not used.
7RVHWXSWKHSULQWHULQ3HHO2II0RGHFRPSOHWHWKHVHVWHSV
1. Remove the rewind plate (if installed) from the front of the printer. Store it on the
two mounting screws on the inside of the front panel.
2. Open the printhead.
3. Slide the media guide and media supply guide as far from the printer frame as
possible. Flip down the media supply guide.
4. Start by loading labels as shown in Load the Printer on page 10.
5. When loading labels, allow approximately 36 in. (915 mm) of labels to extend past
the tear-off/peel-off bar. Remove all labels from this portion to create a leader.
6. Remove the hook from the rewind spindle. If you are using a core, slide it onto the
rewind spindle until it is flush against the guide plate.
7. Wind the label liner around either the 3 in. (76 mm) core or the rewind spindle and
reinstall the hook.
8. Flip up the media supply guide. Slide in the media guide and media supply guide
so they just touch, the edge of the labels. The labels should lie flat.
9. Before closing the printhead, make sure:
The labels are positioned against the inside guides.
The labels are taut and parallel with the pathway when wound onto the rewind
spindle or core.
Media supply guide
Labels
Guide plate
Spindle hook
Rewind spindle
Rewind plate
&DOORXW 'HVFULSWLRQ