Zebra Technologies 3ULQWHUV Printer User Manual


 
Labels and Print Modes
Print Mode Choices
Zebra XiIIIPlus Users Guide 35
Cutter option
If you do not have a cutter, go to Step 4, on page 35.
If you do have a cutter, feed the fanfold labels through the cutter.
4. Slide in the media guide so it just touches, but does not restrict, the edge of the
labels.
5. Close the printhead lever.
5LEERQ5HPRYDO
When the ribbon has run out or must be changed, remove the used ribbon from the
take-up spindle.
If the ribbon has run out, follow the instructions below.
If the ribbon has not run out, open the printhead and tear or cut the ribbon as
close to the ribbon take-up spindle as possible. Follow the instructions below.
7RUHPRYHULEERQIURPWKHWDNHXSVSLQGOHFRPSOHWHWKHVH
VWHSV
1. Open the printhead.
The illustration below and the table that follows show the ribbon take-up spindle.
The inset shows the notches in the spindle.
&DOORXW 'HVFULSWLRQ
Printhead lever
Media guide
Fanfold labels
Caution • The cutter blade is sharp. Do not touch the blade with your fingers.
Note • Do not cut through the ribbon on the take-up spindle. Using the release knob
allows you to slide the ribbon off the spindle. Cutting may damage the spindle.