Filter
Top Products
Appendixes
Specifications and Care
Zebra XiIIIPlus Users Guide 117
7. To reinstall the snap plate, insert the two tabs on the bottom of the snap plate into
the two slots of the media path.
8. Slide the snap plate toward you.
9. Press down on the loops to lock the snap plate into place.
&XWWHU
If the cutter is not cutting the labels cleanly, or if the cutter jams with labels, clean the
cutter.
7RFOHDQWKHFXWWHUFRPSOHWHWKHVHVWHSV
1. Turn Off (O) the printer.
2. Unplug the power cord.
3. Clean the stationary cutter blade with a solvent of 90% isopropyl alcohol.
If this does not remove label fragments and adhesive, contact an authorized service
technician.
Caution • Turn the AC power switch Off (O) and unplug the power cord. The
cutter blade is sharp. Do not rub the blade with your fingers.