128 Zebra XiIIIPlus Users Guide
Appendixes
Troubleshooting
*UD\OLQHVRQEODQNODEHOVZLWKQRFRQVLVWHQWSDWWHUQ
/LJKWFRQVLVWHQWYHUWLFDOOLQHVUXQQLQJWKURXJKDOORIWKHODEHOV
,QWHUPLWWHQWFUHDVHVRQWKHOHIWDQGULJKWHGJHVRIWKHODEHOV
The printhead is dirty. Clean the printhead according to the
instructions To clean the printhead,
complete these steps: on page 114.
There is light printing (or no printing)
on the left or right side of the label or
the printed image is not sharp.
The toggle pressure needs to be adjusted.
Follow the printhead pressure adjustment
instructions in Printhead Adjustment on
page 120.
&DXVH 6ROXWLRQ
The printhead is dirty. Clean the printhead according to the
instructions To clean the printhead,
complete these steps: on page 114.
&DXVH 6ROXWLRQ
The printhead or platen roller is dirty. Clean the printhead, platen roller, or both as
instructed in To clean the printhead,
complete these steps: on page 114.
&DXVH 6ROXWLRQ
There is too much toggle pressure on
the printhead.
Reduce the toggle pressure. See Printhead
Adjustment on page 120.
&DXVH 6ROXWLRQ