Zebra Technologies 3ULQWHUV Printer User Manual


 
Printer Setup and Calibration
Before You Begin
Zebra XiIIIPlus Users Guide 21
7RDGMXVWWKHXSSHUDQGORZHUPHGLDVHQVRUVFRPSOHWHWKHVH
VWHSV
1. Remove the ribbon (if ribbon is used).
2. Locate the upper media sensor. The upper media sensor eye is directly below the
adjustment screw head.
See the illustration for a simplified view of the media sensor. Callouts in the
illustration are explained in the table that follows.
3. Slightly loosen the upper media sensor adjustment screw (use a Phillips-head
screwdriver).
4. Using the tip of the screwdriver, slide the upper sensor along the slot to the desired
position.
5. Tighten the adjustment screw to secure the upper media sensor.
&DOORXW 'HVFULSWLRQ
Upper media sensor
adjustment screw
Upper media sensor
Note • If you are using continuous media, position the upper media sensor over the
labels so that the printer can detect an out-of-paper condition.
2
1