Zebra Technologies 3ULQWHUV Printer User Manual


 
112 Zebra XiIIIPlus Users Guide
Appendixes
Specifications and Care
3ULQWHU&DUH
Cleaning your printer regularly maintains print quality and may extend the life of the
printer.
5RXWLQH3URFHGXUHV
The recommended cleaning schedule is shown in the table below. See the following
pages for specific procedures.
Caution • Use only the cleaning agents indicated. Zebra Technologies is not
responsible for damage caused by any other fluids being used on this printer.
$UHD 0HWKRG ,QWHUYDO
Printhead Solvent*† When &/($1+($'12: appears, or:
Direct Thermal Print Mode: After every
roll of labels or 500 ft. or 150 m of fanfold
labels.
Thermal Transfer Print Mode: After
every roll (1500 ft.or 450 m) of ribbon.
Platen roller Solvent*
Transmissive sensor Air blow
Black mark sensor Air blow
Media path Solvent*
Ribbon sensor Air blow
Label available sensors Air blow Monthly
Tear-off/peel-off bar Solvent*
Snap plate Solvent* As needed
Cutter Solvent*
* Zebra recommends using 90% isopropyl alcohol.
† For 600 dpi printers, use Zebra’s Save-a-Printhead cleaning film.This specially
coated material removes contamination buildup without damaging the printhead.
Call your authorized Zebra reseller or distributor for more information.