28 Zebra XiIIIPlus Users Guide
Labels and Print Modes
Print Mode Choices
8. Load labels as shown in Load the Printer on page 10.
9. When loading labels, allow approximately 36 in. (915 mm) of labels to extend past
the printhead. Remove all labels from this portion to create a leader.
10. Remove the hook from the rewind spindle. If you are using a core, slide it onto the
rewind spindle until it is flush against the guide plate.
11. Wind the label liner around either the 3 in. (76 mm) core or the rewind spindle.
Reinstall the hook.
12. Flip up the media supply guide. Slide in the media guide and media supply guide
so they just touch the edge of the labels. The labels should lie flat.
13. Before closing the printhead, make sure:
• The labels are positioned against the inside guides.
• The labels are taut and parallel to the pathway when wound onto the rewind
spindle or core.
14. Close the printhead.
The labels wind on the rewind spindle or core. The callouts in the illustration and
table that follow show the printer and labels in Rewind Mode.
.
&DOORXW 'HVFULSWLRQ
Printhead lever
Media guide
2
4
3
6
1
7
5
8