Filter
Top Products
32 Zebra XiIIIPlus Users Guide
Labels and Print Modes
Print Mode Choices
13. If you are using a core, slide it onto the rewind spindle until it is flush against the
guide plate.
14. Wind the label liner around either the 3 in. (76 mm) core or the rewind spindle.
15. Reinstall the hook.
16. Flip up the media supply guide.
17. Slide in the media guide and media supply guide so they just touch, but do not
restrict, the edge of the roll.
18. Before closing the printhead, make sure:
• The labels are positioned against the inside guides.
• The labels are taut and parallel with the pathway when wound onto the rewind
spindle or core.
19. Close the printhead.
The labels wind on the rewind spindle or core. The callouts in the illustration and
table that follows show the printer and labels in Rewind Mode with the cutter
option.
&DOORXW 'HVFULSWLRQ
Printhead lever
Media guide
Media supply guide
Labels
2
4
3
5
7
1
8
9
6