110 Zebra XiIIIPlus Users Guide
Appendixes
Specifications and Care
;L,,,3OXVDQG;L,,,3OXV%ODFN0DUN6HQVLQJ2QO\
3RZHU&RUG6SHFLILFDWLRQV
Your power cord must meed these standards:
The overall length must be less than 9.8 ft. (3.0 m).
It must be rated for at least 5 A, 250 V.
The chassis ground (earth) must be connected to ensure safety and reduce
electromagnetic interference.
The ground connection is handled by the third wire (earth) in the power cord as
shown in the illustration callouts and table below.
6SHFLILFDWLRQV ;L,,,3OXV ;L,,,3OXV ;L,,,3OXV
Mark length
(measuring parallel
to label or tag
edge)
0.12 in. (3 mm) F
0.43 in. (11 mm) J
0.12 in. (3 mm) F
0.43 in. (11 mm) J
0.12 in. (3 mm) F
0.43 in. (11 mm) J
Mark width
(measuring to
perpendicular
label/tag edge)
0.43 in. (11 mm) F
Full media width J
0.43 in. (11 mm) F
Full media width J
0.43 in. (11 mm) F
Full media width J
Mark location Marks must be
located within
0.040 in. (1 mm) of
the inside media
edge.
Marks must be
located within
0.040 in. (1 mm) of
the inside media
edge.
Marks must be
located within
0.040 in. (1 mm) of
the inside media
edge.
Mark density in
Optical Density
Unit (ODU)
>1.0 >1.0 >1.0