62 Zebra XiIIIPlus Users Guide
Appendixes
Front Panel Controls
35,17
0(7+2'
Selecting Print Method: Press either black oval to
display choices.
Default: Thermal transfer
Selections: Thermal transfer, direct thermal
The print method parameter tells the printer the
method of printing you wish to use: direct thermal
(no ribbon) or thermal transfer (using thermal
transfer media and ribbon).
Note • Selecting direct thermal when using thermal
transfer media and ribbon creates a printer error
condition, but printing continues.
35,17:,'7+
Setting Print Width:
To increase the value, press the right black oval.
To decrease the value, press the left black oval.
To change the unit of measurement:
1. Press the left black oval until the unit of
measurement is active.
2. Press the right black oval to toggle to a different
unit of measure (mm, inches, or dots).
Default Range: The default and range of acceptable
values vary depending on what printer you have. See
General Specifications on page 94 for further
information about the ranges available for your
model. Print width determines the printable area
across the width of the label.
Note • The printer does not accept any value larger
than the maximum print width listed on Labels and
Print Modes on page 23.
3UHVV /&' 'HVFULSWLRQ