ZyXEL Communications UNS Series Barcode Reader User Manual


 
UNS Series User’s Guide 57
CHAPTER 15
Network Setting
15.1 Overview
This chapter provides information for the network settings in Configuration.
15.2 Network Setting Screen
The Network Setting option is mainly used for accessing the LAN1 port and LAN ports. You can
use this option to configure IP addresses for these network ports. The UNS Series includes the
following network port configuration:
UNS Series: 1 x GbE LAN1 port + 2 x 10GbE port + 1 x GbE port per controller.
Each port must be assigned its own IP address--multi-homed mode, or in present link aggregation
/ trunking mode configurations. Multiple LAN ports are set up in link aggregation mode or trunk
mode allowing all ports to share the same IP address. Click Configuration > Network
Configuration > Network Setting to display the following screen.
Figure 35 Configuration > Network Configuration > Network Setting
The following table describes the labels on this screen.
Table 23 Configuration > Network Configuration > Network Setting
LABELS DESCRIPTIONS
Name Display the LAN1 port or LAN ports.
Link Display the network link status:
Green Light: the link is up and running.
Red Light: the link is down.
LAG Display the link aggregation status.
LAG No Display the link aggregation number.
VLAN ID Display the VLAN number.
Protocol Display IPv4 or IPv6.