ZyXEL Communications UNS Series Barcode Reader User Manual


 
Chapter 15 Network Setting
UNS Series User’s Guide
63
Figure 41 Configuration > Network Configuration > Network Setting > Create Link Aggregation
The following table describes the labels on this screen.
Table 29 Configuration > Network Configuration > Network Setting > Create Link Aggregation
LABEL DESCRIPTION
Link Aggregation or Multi-homed
Aggregation Select the following options from the drop-down menu. At least two network interfaces must
be selected for link aggregation to work.
Trunking: Configure multiple network ports in parallel to increase the link speed beyond the
limits of any single port.
LACP: Allows several physical ports to be bundled together to form a single logical channel.
Balance-alb: Adaptive load balancing for balance-tlb and load balancing-rlb for IPV4 traffic.
DHCP Select DHCP if this network interface uses DHCP.
BOOTP Select BOOTP if this network interface uses BOOTP.
Static Select Static if the network interface uses a manual IP address.
Address Enter the IP address of the network interface.
Mask Enter the mask address of the network interface.
Gateway Enter the gateway address of the network interface.
NIC Select the LAN ports to bond.
Back Click Back to return to the previous screen.
Apply Click Apply to save the changes.
Reset Click Reset to discard the changes.