Filter
Top Products
194 CHAPTER 3: DEVICE CONFIGURATION
Rebooting a
Line Card Port
To reboot a line card port:
1 Select NBX NetSet >
Device Configuration > Line Card Ports.
2 From the list, select the port that you want to reboot.
3 Click Status. The Device Status dialog box appears.
4 Click Reset Device.
5 Click
OK.
CAUTION: On the 3C10117 Analog Line Card, you can reboot individual
ports without affecting the other ports. However, if you reboot a port on
the 3C10117C Analog Line Card, all four ports on the card are rebooted.
Active telephone calls on any of these ports are disrupted.
Details of last 5 calls Information about the most recent five completed calls on a
port:
■ Call Direction: Indicates whether the call originated
from inside the NBX system (outgoing call) or from
outside (incoming call). Values: Incoming, Outgoing.
■ Duration: Length of the call in seconds.
■ Called Party: The number or extension receiving the
call.
■ Calling Party: The number or extension originating the
call.
■ Disconnect: Indicates that a disconnect signal has been
received (the external party has hung up) or not
received. Values: Received, Not Received.
■ DTMF Digits: The digits that were dialed during the
call. This information appears only if the check box is
enabled.
■ Compression: Indicates the audio compression
technique used during the call. MULAW is used for
voice calls. ADPCM is used for voice mail.
Values: MULAW, ADPCM, ALAW, Linear.
Table 34 Device Status Dialog Box Fields (continued)
Field Purpose