Filter
Top Products
20021201
Stop
Syntax: Stop
Function: This command terminates program execution.
Description: This command terminates all program execution, including that of the main
program when a subroutine program is running.
Switch~Case~Default~SwitchEnd
Syntax: Switch
Ⅺ
<expression 1>
Case
Ⅺ
<expression 2>
[<statement>] …
Case
Ⅺ
<expression 3> …
[<statement>] …
…
Case
Ⅺ
<expression n>
[<statement>] …
[Default]
[<statement>] …
SwitchEnd
<expression 1> through <expression n> should be expressions that produce real
numbers.
Function: This command executes one of a series of processes based on the value of
<expression>.
Description
•This command executes the statement following the Case expression that matches the
Switch expression.
• If there is no matching Case expression, the statement following Default is executed. If
there is no Default specified, a non-match jumps to the statement following SwitchEnd.
•You can use a multi-statement command (:) in place of the carriage return to separate
statements.
• Switch~SwitchEnd can be exited using the Break command, Return command, or Goto
command.
Wait
Syntax: Wait
Ⅺ
[<expression>]
Function: This command pauses program execution, and then restarts it after the number
of seconds specified by the expression passes.
Description
• If you do not specify any expression, program execution is paused until you tap the screen,
or press a key.
•The maximum valid specification for <expression> is 360 seconds (six minutes). Specifying
a value greater than 360 causes program execution to resume after 360 seconds,
regardless of the specified value.
•The ClassPad’s Auto Power Off function is disabled during a pause caused by the Wait
command.
12-6-14
Program Command Reference