Filter
Top Products
2-37
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 2 Alarm Troubleshooting
2.7.38 CLDRESTART
2.7.38 CLDRESTART
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Object: EQPT
The Cold Restart condition occurs when an Ethernet card is reseated or replaced, or when the
ONS 15310-CL or ONS 15310-MA power is initialized.
Clear the CLDRESTART Condition
Step 1 If the condition is raised on the controller card, it should clear after booting. If the condition is raised on
an Ethernet card, complete the “Remove and Reinsert (Reseat) a Card” procedure on page 2-154.
Caution Always use the supplied electrostatic discharge wristband when working with a powered ONS 15310-CL
or ONS 15310-MA.
Step 2 If the condition raised against an Ethernet card does not clear, complete the “Physically Replace a Card”
procedure on page 2-154 for the card.
Note When you replace a card with the identical type of card, you do not need to make any changes
to the database.
Step 3 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).
2.7.39 COMIOXC
Default Severity: Critical (CR), Service-Affecting (SA)
SONET Logical Object: EQPT
The Input/Output Slot To Cross-Connect Communication Failure alarm is caused by the 15310-CL-CTX
or CTX2500 card when there is a communication failure for a traffic slot.
Clear the COMIOXC Alarm
Step 1 Complete the “Soft- or Hard-Reset an Ethernet or Electrical Card in CTC” procedure on page 2-153 on
the 15310-CL-CTX or CTX2500 card.
Caution Avoid soft-resetting multiple ONS 15310-MA cards at one time; doing so might cause an unexpected
traffic hit.
Step 2 Verify that the reset is complete and error-free and that no new related alarms appear in CTC. A green
ACT LED indicates an active card.