Filter
Top Products
4-18
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 4 Error Messages
EID-3072 Clear Learned Address Failure attempting to clear the learned MAC
address from a specific card or Ether group.
EID-3073 Clear Selected Rows Failure attempting to clear the learned MAC
address from a specific card or Ether group.
EID-3074 Clear By {0} Error encountered trying to clear the
learned MAC address from either a VLAN
or a port.
EID-3075 At least one row in param column needs to be selected. Refer to the error message text.
EID-3076 CTC lost its connection with this node. The NE Setup Wizard
will exit.
Refer to the error message text.
EID-3077 No optical link selected. Refer to the error message text.
EID-3078 Unable to create optical link. Refer to the error message text.
EID-3079 Cannot apply defaults to node: {0} CTC cannot apply the defaults to the
specified node.
EID-3080 Cannot go to the target tab {0} CTC cannot go to the specified target tab.
EID-3081 Port type cannot be changed. Refer to the error message text.
EID-3082 Cannot modify the {0} extension byte. You cannot modify the specified extension
byte.
EID-3084 Error encountered while trying to retrieve laser parameters for
{0}
There is no card, or there was an internal
communications error when attempting to
get the laser parameters for the card.
EID-3085 No OSC Terminations selected Select an OSC termination and proceed.
EID-3086 One or more Osc terminations could not be created. Refer to the error message text.
EID-3087 OSC termination could not be edited. Refer to the error message text.
EID-3088 No {0} card to switch. No card of the specified type to switch.
EID-3089 Cannot use/change {0} state when {1} is failed or missing. Cannot use or change the specified state
when the card is failed or missing.
EID-3090 Cannot perform operation as {0} is
{1}LOCKED_ON/LOCKED_OUT.
Cannot perform operation.
EID-3091 Cannot perform the operation as protect is active. Refer to the error message text.
EID-3092 Invalid service state. The requested action cannot be applied. Select another service state and proceed.
EID-3093 Cannot perform the operation as duplex pair is {0}locked. Refer to the error message text.
EID-3094 Cannot perform the operation as no XC redundancy is
available.
You cannot perform the requested operation
on the cross connect card without having a
backup cross connect card.
EID-3095 Deletion failed since the circuit is in use Refer to the error message text.
WID-3096 Internal communication error encountered while trying to
retrieve laser parameters. This can happen when equipment is
not present or when equipment is resetting. Check the
equipment state and try to refresh the values again.
Refer to the warning message text.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description