Filter
Top Products
4-40
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 4 Error Messages
EID-6097 The authorization key does not comply with IOS password
restrictions.
{0}
Specify another authorization key.
EID-6098 Default static route is not allowed when default IP Over CLNS
tunnel exists
Refer to the error message text.
EID-6099 You cannot create a subnet on a disabled router. Create the subnet on an active router.
WID-6100 Disabling a router that has a provisioned subnet is not
recommended.
Refer to the warning message text.
EID-6101 The MAT entry already exists. Refer to the error message text.
WID-6102 The new card has less bandwidth than the current card. Circuits
using VT15 and higher will be deleted.
Refer to the warning message text.
EID-6103 The TDC entry already exists. Specify another entry for TARP Data
Cache.
EID-6104 APC ABORTED. Automatic Power Control is aborted.
EID-6105 The 'Change Card' command is valid for MRC cards only when
port 1 is the sole provisioned port.
Refer to the error message text.
EID-6106 To delete all RADIUS server entries, RADIUS authentication
must be disabled.
Disable Radius authentication and proceed.
EID-6107 The node failed to restart the TELNET service on the selected
port. Try using another unreserved port that is not being used
within the following ranges:
23, 1001-9999 (with the exception of 1080, 2001-2017, 2361,
3081-3083, 4001-4017, 4022, 4081, 4083, 5000, 5001, 7200,
9100, 9300, 9401).
Refer to the error message text.
EID-6108 That port is already in use. Restart a TELNET session.
EID-6109 Error: A section trace is active on the trunk port. The action
cannot be completed.
Actions such as putting the port in an
incomplete state are not permitted while a
section trace is active.
EID-6110 Max number of TARP requests reached. You have exceeded the maximum number
of TARP requests.
EID-6111 The card in {0} cannot be removed because it is the protected
card.
Refer to the error message text.
EID-6112 Error adding shelf, {0} The shelf ID specified is invalid or already
exists, the equipment does not support
multishelf, the specified shelf position is
out of range, or the specified shelf position
is already in use.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description