Filter
Top Products
4-20
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 4 Error Messages
EID-3120 No object of type {0} selected to delete. Choose an object of the specified type to
delete.
EID-3121 Error Deleting {0} There is an error deleting the item.
EID-3122 No object of type {0} selected to edit. Choose an object of the specified type to
edit.
EID-3123 Error Editing {0} There was an error editing the item.
EID-3124 {0} termination is in use.
Delete the associated OSPF Range Table Entry and try again
Refer to the error message text.
EID-3125 No {0} Terminations selected. No specified terminations are selected.
EID-3126 {0} termination could not be edited. CTC could not edit the specified
termination.
EID-3127 Unable to provision orderwire because E2 byte is in use by {0}. Refer to the error message text.
EID-3128 The authentication key may only be {0} characters maximum The authentication key cannot exceed the
specified number of characters.
EID-3129 The authentication keys do not match! Refer to the error message text.
EID-3130 Error creating OSPF area virtual link. CTC encountered an error while creating
the area virtual link.
EID-3131 Error creating OSPF virtual link. CTC encountered an error creating the
virtual link.
EID-3132 Error setting OSPF area range: {0}, {1}, false. CTC encountered an error while setting the
area range for the specified values.
EID-3133 Max number of OSPF area ranges exceeded. OSPF area ranges exceeded the maximum
number.
EID-3134 Invalid Area ID. Use DCC OSPF Area ID, LAN Port Area ID,
or 0.0.0.0.
Refer to the error message text.
EID-3135 Invalid Mask Refer to the error message text.
EID-3136 Invalid Range Address The range address is invalid. Try again.
EID-3137 Your request has been rejected because the timing source
information was updated while your changes were still
pending. Please retry.
Refer to the error message text.
EID-3138 Invalid clock source for switching. You have selected an invalid clock source.
Choose another clock.
EID-3139 Cannot switch to a reference of inferior quality. Refer to the error message text.
EID-3140 Higher priority switch already active. You cannot switch the timing source
manually when a higher priority switch is
already active.
EID-3141 Attempt to access a bad reference. Refer to the error message text.
EID-3142 No Switch Active. None of the switches are active.
EID-3143 Error creating static route entry. CTC encountered an error while a creating
static route entry.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description