Filter
Top Products
4-38
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 4 Error Messages
EID-6049 Mode {0} is not supported. CTC does not support the mode of
operation requested on the card.
EID-6050 Some {0} terminations were not {1}d.
{2}
Refer to the error message text.
WID-6051 All {0} terminations were {1}d successfully.
{2}
Refer to the warning message text.
EID-6052 The authentication key can not be blank. Enter an authentication key.
EID-6053 No more SNMP trap destinations can be created. You have reached the maximum number of
SNMP trap destinations.
EID-6054 {0} is not a valid IP address for an SNMP trap destination. The IP address specified is not a valid
receiver of SNMP traps.
EID-6055 The IP address is already in use. Refer to the error message text.
EID-6056 Invalid SNMP trap destination. {0} The specified SNMP trap destination is
invalid. Choose another destination.
WID-6057 Changing the card mode will result in an automatic reset. Refer to the warning message text.
EID-6058 Max number of IP Over CLNS tunnels exceeded. Refer to the error message text.
EID-6059 The specified IP Over CLNS tunnel already exists! Specify another IP Over CLNS tunnel.
EID-6060 Cannot {0} IP Over CLNS tunnel entry:
{1}.
Refer to the error message text.
EID-6061 Error deleting IP Over CLNS tunnel entry. CTC encountered an error while deleting
the IP Over CLNS tunnel entry.
EID-6062 Selected IP Over CLNS tunnel does not exist. Create a IP Over CLNS tunnel.
EID-6063 Selected router does not exist. Create a router.
EID-6064 MAA address list is full. Refer to the error message text.
EID-6065 Selected area address is duplicated. Enter another area address.
EID-6066 Primary area address can not be removed. Refer to the error message text.
EID-6067 Selected area address does not exist. Choose another area address.
EID-6068 The IP Over CLNS NSEL may not be modified while there are
IP Over CLNS Tunnel Routes provisioned.
You cannot change the NSEL address if
tunnels are provisioned.
EID-6069 The node is currently in ES mode. Only router #1 may be
provisioned.
An End System needs only one provisioned
router.
EID-6070 No router selected. Select a router.
EID-6071 Cannot flush TARP data cache. You cannot flush the cache in the Tunnel
identifier Address Resolution Protocol
(TARP) state.
EID-6072 Cannot add TARP data cache entry:
{0}
You cannot add the specified cache entry.
WID-6073 TARP request has been initiated.
Try refreshing TARP data cache later.
Refer to the warning message text.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description