Filter
Top Products
4-6
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 4 Error Messages
EID-2043 This node is not selectable. Only the source node and nodes
attached to included spans (blue) are selectable. Selecting a
selectable node will enable its available outgoing spans.
Refer to the error message text.
EID-2044 This link may not be included in the required list. Constraints
only apply to the primary path. Each node may have a
maximum of one incoming signal and one outgoing link.
You must select only one link going in and
out of a node. Selecting more than one link
is contradictory to the path selection
algorithm.
EID-2045 This link may not be included in the required list. Only one
outgoing link may be included for each node.
Refer to the error message text.
EID-2047 Error validating slot number. Please enter a valid value for the
slot number.
There was an error due to an invalid slot
number.
EID-2048 Error validating port number. Please enter a valid value for the
port number.
There was an error due to an invalid port
number.
EID-2050 New circuit destroy failed. CTC could not destroy the new circuit.
EID-2051 Circuit cannot be downgraded. {0} The specified circuit cannot be
downgraded.
EID-2052 Error during circuit processing. There was an error during the circuit
processing.
EID-2054 Endpoint selection error. There was an error during the endpoint
selection.
EID-2055 No endpoints are available for this selection. Please make
another selection.
This error occurs in the circuit creation
dialog only during a race condition that has
incorrectly allowed entities without
endpoints to be displayed in the
combination boxes.
EID-2056 Communication error. {0} An internal error occurred in Network
Alarm tab while synchronizing alarms with
the nodes.
EID-2059 Node deletion Error. {0} There was an error during the node deletion.
EID-2060 No PCA circuits found. CTC could not find any protection channel
access (PCA) circuits for this task.
EID-2061 Error provisioning VLAN. There was an error defining the VLAN.
EID-2062 Cannot delete VLAN. No VLAN(s) are selected. Please select
a VLAN.
Refer to the error message text.
EID-2063 Cannot delete default VLAN. The selected VLAN is the default VLAN
and cannot be deleted.
EID-2064 Error deleting VLANs.
{0}
There was an error deleting the specified
VLAN.
EID-2065 Cannot import profile. Profile "{0}" exists in the editor and the
maximum number of copies (ten) exists in the editor. Aborting
the import. The profile has already been loaded eleven times.
Cannot import the profile because the
profile has reached the maximum number of
copies in the editor.
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message Description