Filter
Top Products
2-83
Cisco ONS 15310-CL and Cisco ONS 15310-MA Troubleshooting Guide, R7.0
Chapter 2 Alarm Troubleshooting
2.7.126 LCAS-TX-ADD
Note For more information about Ethernet cards, refer to the Cisco ONS 15310-CL and Cisco ONS 15310-MA
Ethernet Card Software Feature and Configuration Guide.
Note ONS 15310-CL ML-100T-8-Series cards are LCAS-enabled.
Clear the LCAS-RX-FAIL Condition
Step 1 Check for and clear any line or path alarms using the procedures in this chapter.
Step 2 If the condition does not clear, log into the Technical Support Website at
http://www.cisco.com/techsupport for more information or call Cisco TAC (1-800-553-2447).
2.7.126 LCAS-TX-ADD
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: STSTRM, VT-TERM
The LCAS VCG Member Transmit-Side-In Add State condition is raised against ML-100T-8 Ethernet
cards when the transmit side of an LCAS VCG member is in the add state. The condition clears after
provisioning is completed. The condition clears after provisioning is completed. The remote likely
reports a path condition such as an “AIS-P” condition on page 2-19 or an “UNEQ-P” alarm on
page 2-142.
Note LCAS-TX-ADD is an informational condition and does not require troubleshooting.
Note For more information about Ethernet cards, refer to the Cisco ONS 15310-CL and Cisco ONS 15310-MA
Ethernet Card Software Feature and Configuration Guide.
2.7.127 LCAS-TX-DNU
Default Severity: Not Alarmed (NA), Non-Service-Affecting (NSA)
SONET Logical Objects: STSTRM, VT-TERM
The LCAS VCG Member Transmit-Side-In Do Not Use (DNU) State condition is raised on ML-100T-8
Ethernet cards when the transmit side of an LCAS VCG member is in the DNU state. For a unidirectional
failure, this condition is only raised at the source node.
The remote node likely reports a path alarm such as AIS-P or UNEQ-P.
Note LCAS-TX-DNU is an informational condition and does not require troubleshooting.