Filter
Top Products
4-3
Compaq ProLiant 1850R Setup and Installation Guide
Writer: Michele Wray Project: Compaq ProLiant 1850R Setup and Installation Guide Comments: 333172-002
File Name: E-ch04.doc Last Saved On: 12/16/98 10:48 AM
COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED
Internal Connectors
The main connectors are the two SCSI Ports (i.e. Port 1 and Port 2), the diskette
drive connector and the IDE connector. They are labeled in the table below.
CAUTION: Do not run internal and external devices off the same
SCSI channel (port). When running external storage boxes, you
should disconnect the internal cable from Port 2.
CAUTION: Remove the two device terminated cables from Port 2
when running external storage devices from SCSI Port 2
embedded controller, that is the Fast SCSI-2 connector.
These connectors are shown below.
1
2
3
3
4
Figure 4-2. SCSI connectors on the system board